PWO高压机床螺杆泵 意大利SEIM三螺杆泵组

PWO系列机床高压冷却泵

安装参数/INSTALLATION DATA

安装-Installation

室内或者户外-Indoor or Outdoor

行业-Envirooment

工业/海事-Industrial/Naval

使用参数/OPERATING DATA

介质-Handled fluid

冷却润滑（乳化液，含油至少5%）-切削液-轻质燃油LFO，LSMGO-重燃油（HFO）-润滑油，矿物合成油
Cooling lubricants (water based emulsions, 5% min. content) - cutting oils -light fuel oils LFO, LSMGO - heavy fuel oils (HFO) - lube oils, mineral and synthetic types

粘度范围-Viscosity

1～10cSt,400cSt-From 1 to 10 cSt typical and up to 400 cSt (*)

泵转速-Pump speed

乳化液和低润滑介质，2900～3500rpm,其他粘度介质可使用不同的转速。使用VFC控制的电机：参看注脚（*）
From 2900 to 3500 rpm with emulsion and low lubricity fluids; other viscosities allow different speeds. Use with VFC controlled motors: apply to note on page foot. (*)

转向（从轴端看）-Rotation（viewed from coupling end）

顺时针（逆时针转向订货需说明）-CW(Std version; CCW on demand)

过滤精度-Recommended filteration

过滤精度≤40μm,不含磨损性污染物
40 micron max, sution side (not abrasive contamiant) ISO 4406 19/16 -NAS 10

技术参数/TECHNICAL CHARACTERISTICS

吸入压力-Suction pressure

-0.5～10bar

排出压力-Delivery pressure

连续工作高达100bar(乳化液)，油介质可达120bar，转速2900rpm
Up to 100 bar continuos (water based emulsions) / 120 bar with oils, at 2900 rpm

工作温度范围-Operating temperature range

0～100℃(*)

轴承类型-Bearing type

农业生产体系械保护的径向密封（标准），机械密封（可选）
Radial seal, with mechanical protection (standard), Mechanical Seal (optional)

轴承润滑-Bearing lubrication

长效润滑-life lubricated

安装形式-Mounting arrangement

水平或立式
Horizontal, or vertical (also vertical semi-submerged, thanks to the intermediate flange).

进出口连接-Inlet & Outlet connection

吸入口:BSP螺纹，出口:SAE3000 - Suction port: BSP thread - Delivery port: SAE 3000

材质/MATERIALS

壳体/法兰-Casting/Flanges

碳钢GG25，GGG-40可选（*）-Cast Iron GG25，GGG-40 on demand(*)

螺杆-Screws

氮化钢（*）-Nitrided steel（*）

O型圈 - O-rings

氟橡胶-Viton

表面保护-Surface protection

按要求提供-On demand

(*) For different values contact Seim S.r.l. - Screws Pumps